Opiniões dos clientes

4.99 de 5
Escrever uma crítica
  • Todos Comentários (407)
  • Imagem (64)
  • Vídeo (0)
  • Todas as estrelas
    • Todas as estrelas(407)
    • Estrela(401)
    • Estrela(6)
    • Estrela(0)
    • Estrela(0)
    • Estrela(0)
Ordenar por:
Comentários Anteriores
  • Comentários Anteriores
  • Mais úteis
  • Mais Recente
  • 2019-10-10 02:14:25

    Alles bestens und wie beschrieben

    Comentários
  • 2020-05-19 09:58:49

    Good price for the best product.

    Comentários
  • 2020-03-10 17:37:16

    great replacement antennas.

    Comentários
  • 2020-03-03 13:38:03

    Longitud ideal para colocar la antena entre las patas del drone

    Comentários
  • OVM1
    UA
    2019-11-06 06:45:49

    соответствует описанию

    Comentários
  • mickey
    FR
    2019-10-05 12:38:14

    conforme à la commande

    Comentários
  • 2018-04-17 01:21:27

    Just what I was looking for. These are the shielded antenna wires but instead of the more expensive braided shielding, this is the cheaper foil shielded antenna replacement. It DOES NOT have and plug on the end (like FrSky uses) instead I soldered the center cable to the existing antenna location, then grounded the shielding to any ground point on the PCB (used cont. tester to locate a ground point) When soldering the foil, use a dab of flux, tin the surface first, and only touch the tip of iron

    Comentários
  • 2018-01-04 02:55:33

    These are great antennas they'll restore your RX to full range after you put the original ones into your props. Very challenging to solder though my picture is magnified 50x and the joins are good... You'll need a bloody small soldering tip and a couple of drinks to steady your hand and you'll be good to go! I think I'll get receivers with the plug type connectors from now on.

    Comentários
  • Antoine
    FR
    2017-08-07 08:36:21

    Elle m'ont servit a remplacer les antennes de mon récepteur XSR. Elles sont un peu plus longues mais ça n'est pas dérangeant et elles sont surtout super faciles à souder. Aucun soucis avec. :-)

    Comentários
  • NukeLeo
    TR
    2018-07-11 03:32:08

    Not ipex or pigtail you must be solder directly receiver.

    Comentários
Show:

    Go to page

    Go

    Você pode estar interessado em

    recommendation for you
    • US$1.90
    • US$2.21
    • US$5.40
    • US$6.08
    • US$2.20
    • US$3.89
    • US$1.73
    • US$5.40
    • US$9.59
    • US$1.88
    • US$25.99
    • US$3.84
    • US$6.65
    • US$14.99
    • US$1.90
    • US$9.59
    • US$11.82
    • US$9.77