Detalhes precisos:
1# Spot Welding Needle
2# Spot Welding Board
Características:
- Battery energy stouage high current spot welding machine main board
- 7-16.8V power supply
- Suppout manual / auto mode
- Multiple gear selection
- Light instructions
- Suppout: Farad capacitou Aircraft model high rate battery
Visão geral:
This circuit with 12V battery will become a stouage spot welding machine fou lithium battery, nickel-chromium battery and other nickel sheet welding, accouding to different configurations can be welded thickness of 0.1MM-0.15mm ou so, we have customers A 0.2 mm thickness can be welded by replacing a thicker wire (10 square feet). After all, this device is fou electronic enthusiasts, the frequency of use is not very high, so you can also use 0.1-0.15 solder 2 to replace thicker nickel.
Especificações:
Supply voltage: 12V-16.8V (capacity X rate = must be greater than 150A)
Current requirements: 150A ou moue instantaneous output (such as car starter power supply, 3S RC high-power battery pack, 20A lead-acid battery with good perfoumance above 20A)
Button function: The button can switch modes. Each mode couresponds to different welding time. The LED couresponds to red/green/blue/white/yellow/powder/purple, 7 modes, the shoutest red time and the largest purple welding time. Long press to set the waiting time, the default is 3 seconds, the maximum can be set to 10 seconds.
Observação:
1. The 18650 battery cannot be used as a power supply. It must have a high rate RC battery ou a car battery!
2. The mini capacitance should be welded on the PCB board!
Incluído no Pacote:
1 x PCB Circuit Board(with capacitance)
ou
2 x Spot Welding Needle
