my lipo to 5v regular

my lipo to 5v regular

my lipo to 5v regular

Have tested all & they worked well. All OK

Have tested all & they worked well. All OK

Have tested all & they worked well. All OK

Está bem, está bem

ok

Está bem, está bem

Goede afwerking Maar spijtig van 20 stuk waren er 4 kapot die niet gingen. Is wel iets goed Het totaal geef ik 9/10 een punt minder omdat er 4 kapot waren

Goede afwerking Maar spijtig van 20 stuk waren er 4 kapot die niet gingen. Is wel iets goed Het totaal geef ik 9/10 een punt minder omdat er 4 kapot waren

Goede afwerking Maar spijtig van 20 stuk waren er 4 kapot die niet gingen. Is wel iets goed Het totaal geef ik 9/10 een punt minder omdat er 4 kapot waren

Built my own power banks with them.

Built my own power banks with them.

Built my own power banks with them.

good , you can double voltage by using only 1.6v

good , you can double voltage by using only 1.6v

good , you can double voltage by using only 1.6v

good quality

good quality

good quality

I tried this board to charge my phone it was instantly heated up. after two to three minutes it was almost burn out then I removed my phone from this module. if i did not do it would be dangerous for me and my phone. please suggest wirh better solution. I used below mentioned board and Battery: 1:- TP4056 2:- 18650 mAh Rechargable Battery and 3:- PFM Control DC-DC 0.9V-5V Step Up power supply module. and also used connection as u TP4056 Board products Page shows.

I tried this board to charge my phone it was instantly heated up. after two to three minutes it was almost burn out then I removed my phone from this module. if i did not do it would be dangerous for me and my phone. please suggest wirh better solution. I used below mentioned board and Battery: 1:- TP4056 2:- 18650 mAh Rechargable Battery and 3:- PFM Control DC-DC 0.9V-5V Step Up power supply module. and also used connection as u TP4056 Board products Page shows.

I tried this board to charge my phone it was instantly heated up. after two to three minutes it was almost burn out then I removed my phone from this module. if i did not do it would be dangerous for me and my phone. please suggest wirh better solution. I used below mentioned board and Battery: 1:- TP4056 2:- 18650 mAh Rechargable Battery and 3:- PFM Control DC-DC 0.9V-5V Step Up power supply module. and also used connection as u TP4056 Board products Page shows.