Placa de proteção de carregador de bateria de lítio 18650 Li-ion 2S 3A Placa PCB BMS
Uma parte da revisão foi traduzida automaticamente.
A simple little protection board for low current (3A or less draw) systems using 2 series lithium cells. The type / size of cell is not important but the chemistry, must be lithium. The Negative ( -) end of the first cell is connected to the PCB terminal marked B- The connections between the (+) positive end of the first cell and the (-) Negative end of the second cell is connected to the PCB terminal marked BM (battery middle?) The (+) Positive end of the second cell is connected to the PCB terminal marked B+ The connection to the load / charge is made to the terminals marked P+ (7.5V nominal) and P- (GND Negative) Operation is simple. If either of the 2 series cells exceeds the upper voltage limit or drops below the lower voltage limit, the load / charge connection disconnects. The load / charge connection reconnects when the voltages are normal again. This may be the basis of a simple charge limiting circuit and over discharge protection circuit. The board is well made and works as it should. I hope this clears up some of the questions raised.
Nabíjací a ochranný obvod pre 2ks spojené Li ion batérie 18650 2S 7,4 V. Balenie po 5 ks.
Chegou rapidamente
muito bom recomendo 🤝🏿
Comprada para proteger baterias externas para módulo externo r9m. As almofadas a soldar são delicadas. A 385°, separam-se e movem-se.
Entrega rápida. Funciona bem
good quality, it's working, very small dimensions
chegou muito rápido, ainda não tentei, mas parece bom quando eu tento eu vou comentar mais
nice and small
O K Muito bom.