Uma parte da revisão foi traduzida automaticamente.
So far tested just on bench. RE & DE can be connected and be driven by only one signal line, because RE (enable receiver) is active low and DE (enable transmitter) is active high. Note: in such configuration protocol have to be able to ignore possible noise on the bus. All signals are connected to pins and bus is also connected to screw terminals on top side of module. Note: polarity of bus lines is important and needs to be same on all transceiver on bus. Due to IC datasheet (it's MAX485) there can be 32 transceiver on one bus.
They look good. I didn't test them yet but I assume they will work fine.
Produto de acordo com a descrição do anúncio
This should be in a "bus" kit for Arduinos as it is a good education tool for learning all the micro busses, like RS232, RS485, I2C, SPI, CANBUS, etc.
excelente relação custo-benefício e bom serviço
Produto conforme. Funcional.
Está bem, está bem
Está bem, está bem
Excelente
Chegou a horas apesar das restrições de viagem devidas à Covid-19 Foi devidamente embalado e em boas condições. Mas ainda não o testei.