Opiniões dos clientes

Escrever uma crítica
  • Todos Comentários (32)
  • Imagem (1)
  • Vídeo (1)
  • Todas as estrelas
    • Todas as estrelas(32)
    • Estrela(30)
    • Estrela(2)
    • Estrela(0)
    • Estrela(0)
    • Estrela(0)
Ordenar por:
Comentários Anteriores
  • Comentários Anteriores
  • Mais úteis
  • Mais Recente
Comentários apenas do seu país (Portugal)
|
Mostrar original

Uma parte da revisão foi traduzida automaticamente.

  • 07/06/2016

    Basically a breakout board for the processor. Includes USB connection (2x 22Ohm resistors in series with D+ and D- and a D+ pull up resistor connected through jumper P2). All pins nicely labeled. Includes 8MHz and 32kHz cystals, power LED and 20 pin JTAG connector. Boot 0 and 1 pins brought out to 2.4mm pin header for boot mode selection. Serial connections have their own 4pin header with GND and 5V. Nothing else. A good point is V_BAT is brought out to pin header as well. Schematics can be found if you search by "lctech-stm32-devboard-scheme", but the only thing that needs explanation is jumper P2. The bad part: Soldering of SMD components is just passable We have come to expect better even from China. Soldering of through hole components is not very good. Pin headers are on crooked. Some people may prefer pin headers soldered at the other side. Banggood hear us: Please offer this product with pin headers left off! Overall, a good product which will benefit from better through hole soldering, or better, pin headers completely left off.

    Comentários
    Mostrar original
  • 25/11/2014

    I have seen it listed on other sites but not a this this price. I connected it to J-link JTAG,USB power , Open KEIL, compile test project and it worked. Just as I was expecting.

    Comentários
    Mostrar original
  • 19/05/2015

    Great board for the best price. The Cortex-M3 CPU is great, very powerful and the chip has tons of periphery. I like the fact the board has the RTC xtal mounted. Great open source support - libopencm3 + GNU ARM toolchain + Eclipse. + OpenOCD.

    Comentários (3)
    Mostrar original
  • LMPVIP4
    PT
    14/01/2020

    Está bem, está bem

    Comentários
    Mostrar original
  • 12/06/2016

    Zum Download über TX RX die Bootjumper *- BOOT0 -* BOOT1 so stecken. Nutze dafür den CH340 in NANO (Achtung Widerstände anpassen sonst langen die Pegel nicht und RESET jumpern) Es gibt nun auch noch eine schmälere Version.

    Comentários
    Mostrar original
  • 17/04/2014

    Perfect small board to start with STM32 development, well constructed and has everything required...

    Comentários
    Mostrar original
  • 03/01/2016

    Tested with some small project with GNU ARM compiler and Open CMSIS library. Very good results. Thanks for good product.

    Comentários
    Mostrar original
  • 11/12/2020

    O produto corresponde à descrição.

    Comentários
    Mostrar original
  • 25/09/2020

    Ainda não testado, recebido 7 dias após o pedido ter sido feito

    Comentários
    Mostrar original
  • 01/09/2019

    Impeccable ! Article d'une Qualité irréprochable et Conforme à sa description...

    Comentários
    Mostrar original
Show:

    Total 0 Páginas

    Vá para página

    Vai
    recommendation for you
    • US$10.99
    • US$3.99
    • US$5.99
    • US$6.99
    • US$5.99
    • US$3.99
    • US$11.49
    • US$24.49
    • US$11.49
    • US$16.09
    • US$61.41
    • US$33.62
    • US$39.99
    • US$9.99
    • US$10.48
    • US$43.34
    • US$24.14
    • US$47.29