Opiniões dos clientes

Escrever uma crítica
  • Todos Comentários (12)
  • Imagem (4)
  • Vídeo (0)
  • Todas as estrelas
    • Todas as estrelas(12)
    • Estrela(11)
    • Estrela(0)
    • Estrela(0)
    • Estrela(0)
    • Estrela(1)
Ordenar por:
Comentários Anteriores
  • Comentários Anteriores
  • Mais úteis
  • Mais Recente
Comentários apenas do seu país (Portugal)
|
Mostrar original

Uma parte da revisão foi traduzida automaticamente.

  • 22/03/2024

    A remessa chegou a tempo e tudo está funcionando corretamente com controles simples. O único problema é que você deve usar um carregador adequado (mínimo 2A) caso contrário, ele fica louco!

    Comentários
    Mostrar original
  • 10/04/2024

    10/10 excelente carregador

    Comentários
    Mostrar original
  • 07/04/2024

    This is a good and versatile charger. Below I'll give some additional info you won't find in the user manual. 1) Short touch any key to turn on the backlight. It will stay on for 30 seconds, then it will automatically turn off. 2) Long touch the Current key until the beep tone stops. This will turn on the backlight permanently. Repeat this two times to turn the backlight off. 3) The charging process of Li-ion batteries will will be terminated at 4.22V but the display shows 4.20V. This is +0.48%, barely within the usual tolerance of +/-0.5% given for other chargers. I wish it were closer to 4.20V. Other pieces of this type may vary. 4) In Discharge and Test modes Li-ion batteries will be discharged to 2.82V. This is no problem with the charger, this is the usual way to test capacity but not so good for the battery. So don't use these features too often! My personal opinion is that the max. discharge current of 500mA is too small, it takes 15+ hours to test a 5000mAh battery. This is way too long, I miss an option for 1000mA discharge current. On the other hand you don't test batteries even on a weekly basis, so you can let the charger take its time. 5) Disconnect the USB input cable to enter USB power bank mode. The device draws 150mA from the battery in standby mode, including the backlight, which is always on in this mode. With a load of ca. 1300mA it draws 2A from a full battery. At first glance it may seem bad efficiency but it is not because the 4V battery drives a boost converter to produce the 1300mA at 5V. This requires ca. 1625mA from the battery, plus the 150mA standby current. So the efficiency of the boost converter is 1625/(2000-150) = 87%. This is very good. All in all, this is an excellent product, very good value for your money. Highly recommended!

    Comentários (1)
    Mostrar original
  • 02/04/2024

    muito bom

    Comentários
    Mostrar original
  • 28/01/2024

    Envio rápido, embalagem boa, carregador com muitas funções úteis. Ótimo para testar baterias antigas e visualizar a capacidade residual exata, também mostra a diferença entre a carga feita e a descarga obtida em mAh. Possui 4 canais verdadeiramente independentes e pode ser usado com qualquer fonte de energia USB com pelo menos 2A de saída. Altamente recomendado!

    Comentários
    Mostrar original
  • 13/05/2024

    O carregador é muito bom. Repara baterias antigas. Verifica a condição dos acumuladores. Estou satisfeito.

    Comentários
    Mostrar original
  • 19/03/2024

    foi super rápido, eu recomendo

    Comentários
    Mostrar original
  • 22/02/2024

    Unidade muito útil. Foi usado por um mês e funciona como descrito.

    Comentários
    Mostrar original
  • 08/01/2024

    this is a great product. I suggest.

    Comentários
    Mostrar original
  • 03/01/2024

    I was blown away by the speed of the delivery and the professionalism. the product is better than I had expected I am very pleased with it

    Comentários
    Mostrar original
Show:

    Total 0 Páginas

    Vá para página

    Vai

    Você pode estar interessado em

    recommendation for you
    • US$16.99
    • US$6.25
    • US$13.52
    • US$20.78
    • US$15.99
    • US$11.18
    • US$13.36
    • US$6.97
    • US$16.59
    • US$26.23