123 Change the receiver's protocol from SPEKTRUM2048 to SPEKTRUM1024
Resposta 04/02/2018Tatjana Leto You have to setup your transmitter from 1000-2000 otherwise it will nont arm.
Resposta 07/02/2018highks Maybe there is a throttle-cut programmed for one of the switches? You\'d need to disable the throttle cut to start the motors. You can look at the programming of all the switches by connecting the quad to betaflight.
Resposta 08/02/2018highks You need to flip the arm switch in order to get the motors spinning. Don't know where that switch is on this quad or on your transmitter, but you can look it up in betaflight.
Resposta 12/02/2018borvanbeers Did you arm the quad? Google on how to do this if you haven't already armed it.
Resposta 15/02/2018Jesse Have you configured it in Betaflight? You may need to connect it to your computer and change a few settings?
Resposta 18/02/2018Klaus_R same problem here; learning a lot about deviation and betaflight - but obviously not enough to program an arming switch on my TBSG :/
Resposta 19/02/2018redfactorman there is a youtube video that covers connecting a DSM2 in betaflight.
Resposta 22/02/2018AdrianD90 Have you changed the arming sequence in betaflight to a switch and checked for low throttlejQuery19106909420793233754_1519818236483
Resposta 28/02/2018Fernando I had trouble arming until I lowered the throttle trim
Resposta 16/03/2018Nossa Empresa | Entre em contato conosco | Pagamento & Envio | Programas de Parceria |
---|---|---|---|