Geekcreit® D1 Mini Single Lithium Bateria Carregando e Bateria Boost Shield Board
Uma parte da revisão foi traduzida automaticamente.
That little shield works perfectly with my WiFi Scanner. Small size, but powerful :)
Muito útil para adicionar uma opção de bateria a um D1 Mini. Este não tem a opção de resistor e jumper de 130k para conectar a bateria positiva à entrada A0 ADC para ler o nível da bateria. Isso é facilmente feito soldando um resistor de 130k diretamente entre o conector da bateria e o A0. Isso fornece uma faixa de entrada máxima ADC de 4,5 V, o que é suficiente para uma bateria Lipo. Para obter a voltagem da bateria, leia a entrada ADC e multiplique por 4,39 para obter a voltagem da bateria em milivolt.
Este Wemos tiene buena calidad. Es el indicado para los dispositivos IoT que requieran batería. Se agradece que sus pines vengan sin montar porque da más opciones de montaje y sería bueno que el de la batería también venga sin montar pero no es un problema. Viene todo bien indicado en la serigrafía con su opción de J1 para 1A y 0.5A incluso tiene pads para poder usar los D+D- del usb lo cual está muy bien. Recomiendo probarlos apenas lleguen por si hay que reclamar ya que claramente se indica en su bolsita No Test.
Das Anschließen dieser Platine ist selbst für Laien problemlos. Leider ist beim Versand ein kleines Plastikteil für den Anschluss der externen Batterie abgebrochen. Was allerdings keine Beeinträchtigung der Nutzung ist.
Пока не проверял. Выглядит хорошо.
Looks ok
The order was delivered in perfect conditions
Does the job nicely as a wemos self-ups :) Beware though, it does not have the J2 jumper described on wemos.cc wiki to measure the batt' voltage on the A0 pin. On this version, the A0 pin in unconnected, you have to do the connection by hand if you need to read battery voltage. Beside that, everything is OK :)
Bonne finition, le layout Pcb est propre, composants biens soudés
Not tested yet but visually as advertised.