Opiniões dos clientes

4.83 de 5
Escrever uma crítica
  • Todos Comentários (539)
  • Imagem (56)
  • Vídeo (0)
  • Todas as estrelas
    • Todas as estrelas(539)
    • Estrela(485)
    • Estrela(28)
    • Estrela(18)
    • Estrela(6)
    • Estrela(2)
Ordenar por:
Comentários Anteriores
  • Comentários Anteriores
  • Mais úteis
  • Mais Recente
  • March-12 2020 19:50:29

    Love it excellent FPV AIO Camera n vtx n excellent picture from it.

    Comentários (1)
  • December-08 2019 08:12:36

    awesome little mount for my tx01, just what I needed for my e010 mods

  • January-30 2020 08:00:55

    works great, if you tighten it too much to the board the mount will push the bind button on the beecore 2.0, but minor problem.

  • January-25 2020 08:51:51

    when I got

  • January-18 2020 15:38:13

    non si adatta perfettamente ma con pochissime modifiche ho risolto

  • September-07 2017 08:14:25

    The front hole is OK, but the two side hole is just decoration for me. It needs a very long and skinny screws, what I don't have, so I fixed it with a rubber, wich is hold the cam in place well. Overall it's do the job, and holds the camera angle also in good position!

  • July-09 2017 05:37:07

    Print quality is a little scratchy, but it fit fine on my Furi-Whoop It's taken some tumbles from higher than one floor of my apartment and it's still holding together. You will need to add a cable tie, or a dab of hot glue to hold the camera in proper, but otherwise it's a good fit. If you're thinking about a custom colour, be aware that sharpie will not stick. Try paint or dye.

  • April-08 2019 06:44:50

    к сожалению не подошла по размеру к моей камере, но всегда можно подрезать и посадить на суперклей)

  • October-03 2018 09:58:45

    Òtima mercadoria, ótima qualidade, gostei muito da mercadoria, já voei usando esse suporte e ele é muito bom, parabéns.

  • October-11 2017 21:56:56

    Крепление крепкое, держит отлично. Очень похоже на печать 3D принтером.


    Go to page

    recommendation for you