Idioma
Enviar para 
United Kingdom , USD
United Kingdom , USD
United Kingdom , USD
derwisch999 Hello, can you please share the datasheet of this attenuator? I searched for it but I couldn't find anything but some similar models. I programmed six pins (on the top) a binary counter 0 to 63, increases 0.5dB per 0.5 seconds. But I can't see the change of the received signal on the spectrum analyzer on the frequency domain. Should I use the two pins on the bottom of the board?
Resposta 12/12/2019
christopher Hello, can you please share the datasheet of this attenuator? I searched for it but I couldn't find anything but some similar models. I programmed six pins (on the top) a binary counter 0 to 63, increases 0.5dB per 0.5 seconds. But I can't see the change of the received signal on the spectrum analyzer on the frequency domain. Should I use the two pins on the bottom of the board?
Resposta 12/12/2019
christopher Hello, can you please share the datasheet of this attenuator? I searched for it but I couldn't find anything but some similar models. I programmed six pins (on the top) a binary counter 0 to 63, increases 0.5dB per 0.5 seconds. But I can't see the change of the received signal on the spectrum analyzer on the frequency domain. Should I use the two pins on the bottom of the board?
Resposta 12/12/2019
christopher Hello, can you please share the datasheet of this attenuator? I searched for it but I couldn't find anything but some similar models. I programmed six pins (on the top) a binary counter 0 to 63, increases 0.5dB per 0.5 seconds. But I can't see the change of the received signal on the spectrum analyzer on the frequency domain. Should I use the two pins on the bottom of the board?
Resposta 12/12/2019
christopher Hello, can you please share the datasheet of this attenuator? I searched for it but I couldn't find anything but some similar models. I programmed six pins (on the top) a binary counter 0 to 63, increases 0.5dB per 0.5 seconds. But I can't see the change of the received signal on the spectrum analyzer on the frequency domain. Should I use the two pins on the bottom of the board?
Resposta 12/12/2019
christopher Hello, can you please share the datasheet of this attenuator? I searched for it but I couldn\'t find anything but some similar models. I programmed six pins (on the top) a binary counter 0 to 63, increases 0.5dB per 0.5 seconds. But I can\'t see the change of the received signal on the spectrum analyzer on the frequency domain. Should I use the two pins on the bottom of the board?
Resposta 12/12/2019| Nossa Empresa | Entre em contato conosco | Pagamento & Envio | Programas de Parceria |
|---|---|---|---|
39% OFF
