Motor Driver muito bom para Pi 3. Funciona muito bem em robô DIY.

Very nice Motor Driver for Pi 3. Works very good in DIY robot.

Motor Driver muito bom para Pi 3. Funciona muito bem em robô DIY.

Está bem, está bem

ok

Está bem, está bem

O chapéu está ok, mas os jumpers de endereço seriam muito úteis e a documentação é muito difícil de encontrar seria bom se ele fosse incluído

The hat is ok but address jumpers would be very useful and documentation is very hard to find it would nice if it was included

O chapéu está ok, mas os jumpers de endereço seriam muito úteis e a documentação é muito difícil de encontrar seria bom se ele fosse incluído

These instructions are not sufficient for me to use this product

These instructions are not sufficient for me to use this product

These instructions are not sufficient for me to use this product

Using this with the Pi great for the purpose I needed it for

Using this with the Pi great for the purpose I needed it for

Using this with the Pi great for the purpose I needed it for

Exelente

Exelente

Exelente

havent used but well packed

havent used but well packed

havent used but well packed

Information on the board can be a bit hard to find, but it is out there. It is a nice board for controlling motors and servo's. This model does not have the stacking headers, so it is a bit harder to use more then one of them without either changing the hadder, or putting in jumpers for the I2C bus. The board does have solder pads to let you change the address of the board.

Information on the board can be a bit hard to find, but it is out there. It is a nice board for controlling motors and servo's. This model does not have the stacking headers, so it is a bit harder to use more then one of them without either changing the hadder, or putting in jumpers for the I2C bus. The board does have solder pads to let you change the address of the board.

Information on the board can be a bit hard to find, but it is out there. It is a nice board for controlling motors and servo's. This model does not have the stacking headers, so it is a bit harder to use more then one of them without either changing the hadder, or putting in jumpers for the I2C bus. The board does have solder pads to let you change the address of the board.

Have not tried it yet but hoping that I can find drivers for it soon.

Have not tried it yet but hoping that I can find drivers for it soon.

Have not tried it yet but hoping that I can find drivers for it soon.