Todas as mensagens

Q: TO ĆO MATE ZA LINK KED NEBERIE ODPOVEDE

perguntado por ondrej sobre 2022-07-20 03:11:17

The seller If you have questions, you can send an email for customer service help

2022-08-04 03:37:21 Útil (1)
Enviar
respostas (1)

ondrej navod Vypnem svetlo nesvieti nič ani senzor. Zapnem 1) x lampa mi svieti silno potom zhasne a keď spravím pohyb nad (senzorom) lampa sa rozsvieti zakym sa pohyb robí senzor reaguje lampa svieti silno stále. Ked spínač stlačím druhy krát lampa svieti slabo potom začne silno a potom sa prepne na slabšie svetlo a svieti stále. Zapnem 3 krát spínač a lampa mi svieti slabšie také intímne svetlo a svieti stále v kuse musíme vypínačom vypnut alebo nechať svieti až do denného svetla malo by vypnut a začne nabitie baterku

ondrej 28/06/2022
0
Comentários (1)

ondrej DC 12V 150W 13000rpm 775 Motor Micro DC Motor 5mm Shaft Motor MOTOR JE KROKOVY NA DC POSKAKUJE A AC LEN DRNĆI AKY PLOšAK KU TOMU

ondrej 01/03/2022
0
Comentários (1)

ondrej Electric wave clock movement instruction book: (also do not understand, please contact Customer Service) 1. Overview: RCC switch in ON position, with radio wave receiving function, such as dial in OFF position, without radio wave receiving 2. Start: Put the alkaline battery (AA1.5V, LR6) into the battery tank (pay attention to the polarity of the battery), you can see the second hand for sweeping and moving (sometimes you need to press the reset key), after sweeping zero to 12: 00, when the minute needle also starts to sweep zero to 12: 00, the three needles enter the receiving State after scanning zero, and start receiving the radio wave signal. This process takes 3-15 minutes. After receiving the time, the pointer will automatically go to the correct position and start walking. When the RCC switch is turned on the OFF position, the radio wave is not received, and the zero is swept to 12: 0, and the time is immediately gone. 3. Manual adjustment: In the non-sweep, chasing, etc. state, both normal walking time can be manually adjusted. Press the SET key or above more than 3 seconds, all the pointers stop, the minute pin goes 6 times (1 minute), and enters the manual state. When you press and hold the SET key for more than 1 second, the minute and minute hands turn quickly. If you press the SET key below (less than 1 second), add 1 minute. If the user does not operate the SET key and REC key, after about 30 seconds, automatically exit the manual adjustme

2019-12-21 02:04:42 Útil (0)
Enviar
respostas (2)