AngryPlum
AngryPlum from my limited use of the device, it remains in pulse/repair mode until the nominal voltage is raised above 12.8v or there about. it then switches to charge mode until full (full displayed) after which it switches to trickle mode keeping the voltage somewhere between 12.8 and 13.6 (the recommended floating voltage, depending on temperature). the problem is with a damaged battery it will never reach 12.8 and will literally pulse it dry, even quicker with one or more dead cells.
2019-08-09 12:06:06 Útil (0)Q: Is the charging current constant at 5 to 6 Amps or variable according to the battery specification ?
perguntado por adriansstephenson sobre 2019-07-23 08:59:31
AngryPlum in the standard charge mode this charger limits the voltage to 14.8v by current limiting. smaller capacity batteries have a lower internal resistance and will therefore reach the aforementioned voltage "easier/sooner" thus restricting the max current sooner. case in point charged a 14ah lead acid from near flat. max current never exceeded 2.2A. this is still too high for small batteries, causing accelerated evaporation so keep an eye on electrolyte levels. especially when using repair.
2019-08-09 11:58:59 Útil (2)
AngryPlum During pulse repair phase, the charger sends high frequency minimal duty cycle high voltage pulses into the battery. If the battery is very sulfated, these cause the float voltage (the one indicated) to go above the normal end voltage for 6 cell lead acid batteries (14.7V). On some of the higher current chargers that i've built it has gone as high as just over 20V, but soon drops down as the internal resistance subsides (due to repair process).
Sinceramente, o convidamos a se inscrever para receber o e-mail de resposta ao convite!
Se você se inscrever, nós o convidaremos por e-mail para responder a perguntas que as pessoas tenham sobre os produtos. Ao se inscrever, você] também ganhará o "Emblema de útil "! Você pode cancelar a assinatura a qualquer momento na página de configurações de privacidade.
Ajude os outros e seja mais feliz!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
.JPG)
AngryPlum @toolgeek hierdie ligte is vol spektrum vir plante (want hulle is kleur blind) en is gelykstaande aan sonlig. so vir flowering verander jy net die lig siklus. niks ander ligte word benodig nie, tensy die spesifieke strain meer rooi of blou kort(maar dit is baie skaars). hier is bietjie goeie raad... die eenhede se verkoeling is passief en hulle loop warm. so maak seker dat die AC die temperatuur laat genoeg hou en dat die waaiers op die ligte ook waai.