Todas as mensagens

Q: is the Power supply Standard select to 220V or 110 Volt ?

perguntado por b.stadler sobre 2019-10-10 02:32:12

jdill There is a switch inside the case that is used to select 110v or 220v. Mine had a sticker on the side of the case to warn of it.

2020-01-17 04:02:21 Útil (1)
Enviar
respostas (1)

jdill The 3 output terminals for V- and for V+ seem to use a common feed, so using just two terminals should be OK.

2020-01-17 03:55:15 Útil (0)
Enviar
respostas (2)

Q: wich prop Is better for 4s?

perguntado por barrosjuaneduar sobre 2019-04-05 07:59:36

jdill I'm using it with a 12x6 propeller and it draws 36.8 amps and 495 watts at full throttle. The amperage of the motor isn't listed in the specifications but since they show 35 amps in the "Testing Data" it may be a 40 amp motor. So 37 amps should be no problem, especially for short periods.

2019-05-11 05:35:42 Útil (1)
Enviar
respostas (1)

jdill Try this: download and run the ImpulseRC Driver Fixer. It puts the flight controller into BOOT mode. Then run Cleanflight and use the Firmware Flasher to update the quad. Worked great for me on a QX90.

Knockedup 20/09/2017
0
Comentários (2)