Todas as mensagens

Q: Are the ones that ship now any good or still overheating?

perguntado por Albin Konradsson sobre 2019-07-29 04:00:39

akibafreek Yes. I will not buy it anymore

2019-08-02 12:36:56 Útil (0)
Enviar
respostas (1)

Q: Lamination thickness?

perguntado por Albin Konradsson sobre 2019-03-15 12:23:49

babel101 good question !!! look I g forward for answer

2019-03-17 10:48:28 Útil (0)
Enviar
respostas (1)

Q: How many amps does the BEC provide? Can you provide pinouts for remaining UARTS?

perguntado por Albin Konradsson sobre 2018-09-15 01:19:19

Meatusreff NO BEC output.- SBUS/IBUS/DSMX receiver please configure RX1 (UART1) as input, and enable Serial_RX - PPM receiver don’t need to enable Serial_RX - DSM/DSM2/DSMX receiver power from 3.3V - SBUS and PPM receiver power from 5V

2018-10-03 10:01:30 Útil (0)
Enviar
respostas (1)

Q: Please publish some thrust data.

perguntado por Albin Konradsson sobre 2018-02-14 04:07:03

Proto_pathy The thrust data haven't publish from brotherhobby. Banggood will publish it once they have these data.

2018-03-18 09:48:39 Útil (0)
Enviar
respostas (1)

Q: What is the target for INAV?

perguntado por Albin Konradsson sobre 2018-01-21 01:25:37

pawel Confirmed. The OMNIBUSF4PRO 1.9.1 target is fully operational for HAKRCMINIF4 board. All sensors (including GPS on UART6 and MAG on I2C shared with UART3) working fine. ESC's outputs are correctly assigned, serial SBUS receiver connected to UART1 work ok, LED2812, as well as OSD are also fine. I've used GPS/MAG Bentian-BN-880 (set up on HMC5883 and UBLOX in INAV configurator). Baro should be set up on BMP280 and accel on MPU6000. Good luck!

2018-05-25 10:45:03 Útil (4)
Enviar
respostas (6)