Todas as mensagens

Q: Which target for flashing Betaflight?

perguntado por CorpseGuard sobre 2020-12-14 11:14:36

Johnnysod As said before Matek405 However the other comment about voltage is incorrect The VTX supply voltage is 10v but the accepted voltage on the new design is Input voltage & power dissipation: 7V~24V, +12V 260mA@600mW So is fine. Just add an extra wire to get smart audio on port 3. The flight controller is the one listed for the Tyo129. Quite nice. Has lots of ports. Add GPS if you want. Buzzer connection and S6 for Cam control if you upgrade the camera to say Cadex Ratel

2020-12-15 03:37:41 Útil (3)
Enviar
respostas (5)

Q: how to be procedure to switch PAL / Ntsc ???

perguntado por m.capasso.77@gmail.c sobre 2019-10-10 07:38:38

Johnnysod Betflight can't tell the camera to switch Pal or NTSC as it doesn't send it data. There must be a bridge to switch it but I don't know where. The next time I take the camera out I'll have a look...

2020-11-24 09:59:39 Útil (0)
Enviar
respostas (3)

Q: how to use Frsky xm+(SBUS)?

perguntado por noobFPV sobre 2020-11-14 10:16:36

Johnnysod Solder the SBus pads and use UART 6

2020-11-24 06:10:20 Útil (0)
Enviar
respostas (2)

Johnnysod Not sure there is a futaba receiver, but you could fit a small one to the no receiver version. It's a fantastic drone, I use a T16i Radiomaster touch screen transmitter.

2020-10-29 12:14:39 Útil (0)
Enviar
respostas (1)

Q: the trasmitir have a bag?

perguntado por miguelnavrib sobre 2020-03-24 02:26:37

Johnnysod It shows the Box in the last picture

2020-04-30 03:09:29 Útil (0)
Enviar
respostas (4)