Todas as mensagens

Q: does it work with FlySky I6?

perguntado por silviobraendle sobre 2019-11-06 09:39:39

efrancois Testedwith a Taranis QX7 only

2022-07-04 12:21:12 Útil (0)
Enviar
respostas (2)

Q: does it fit M8*0.5mm lens thread?

perguntado por silviobraendle sobre 2019-10-26 03:14:59

BG145716125 all ok

2022-02-26 04:16:22 Útil (0)
Enviar
respostas (3)

HamsterHybrid Wennthe module is in "SET" mode, you can't send and receive commands, because the module awaits your settings via Serial. There is no need to constantly have the SET pin grounded, usually you set the module's settings once and that's it.

2021-10-29 05:56:59 Útil (0)
Enviar
respostas (2)

Q: does the bottom conduct?

perguntado por silviobraendle sobre 2019-11-10 07:02:03

Henrik NO! The adhesive does NOT conduct. You might get an (unreliable) contact at the edge of the tape, but NOT through the adhesive.

2021-10-25 03:36:24 Útil (0)
Enviar
respostas (2)

JT_Enliten You may use the Uart pins for the two Arduino boards to connect each other, but you also need to wire their GND pins together.

2021-09-19 02:14:44 Útil (0)
Enviar
respostas (2)

The seller Here https://www.banggood.com/30_5x30_5mm-MAMBA-F405-MK2-3-6S-Flight-Controller-compatible-DJI-FPV-Air-Unit-for-RC-Drone-FPV-Racing-p-1855166.html?cur_warehouse=CN

2021-06-03 06:08:29 Útil (0)
Enviar
respostas (1)