Todas as mensagens

Q: Are these 110mm end to end, or is 110mm between the Pin centres?

perguntado por Happless sobre 2020-09-28 04:29:56

Sushijjgg99 110mm is total end to end length

2020-10-02 04:43:11 Útil (3)
Enviar
respostas (3)

Happless Yes it appears these 2 will work. Just need to use the rx6 pad on the board for the IBUS line

2021-01-25 10:15:50 Útil (0)
Enviar
respostas (1)

Q: would this be a good motor combo for a zd racing pirates 3 roller chassis

perguntado por BG231491431 sobre 2020-06-28 11:06:20

Happless This is pretty much the same setup I run on that chassis. I would say one thing, you will NEED the wheelie bar. It is devastatingly hilarious the ease with which this setup will make make my Monster Truck wheel stand.

2020-10-01 11:23:11 Útil (0)
Enviar
respostas (3)

Happless You could go the ZD racing one, but then you gotta replace your RR lower suspension mount and replace it with plastic one on wheelie bar. Better bet would be one like the BSR Berserker uses.

2020-10-01 12:36:46 Útil (0)
Enviar
respostas (2)

Q: do these still catch on fire🔥

perguntado por foolfpv sobre 2019-02-26 08:38:13

Happless OK, you gotta elaborate on that one.

2019-02-26 08:48:54 Útil (0)
Enviar
respostas (4)

Q: TX/RX Requirements?

perguntado por Happless sobre 2018-12-24 09:01:54

scousethief You use your own Transmitter and micro receiver with esc

2019-01-17 01:51:49 Útil (0)
Enviar
respostas (1)

Q: Does this just use standard AA/AAA batteries? Also, is it all wheel drive?

perguntado por Happless sobre 2018-12-02 10:08:48

rcaddict Yes, it's all wheel drive.

2019-02-20 04:12:13 Útil (0)
Enviar
respostas (2)

Q: Will spare parts be available for this?

perguntado por Happless sobre 2018-08-03 05:28:14

Conatus Which parts do you want?

2018-08-06 02:05:11 Útil (0)
Enviar
respostas (1)

Happless Hi Spence92 just wondering, what else have you used to convert the hyper 7 as mine is sitting unloved atm due to a seized nitro motor

Spence92 12/03/2018
0
Comentários (2)