Work perfectly with low temperature Poss: - no residue after welding - low temp - no clean Con : no lead : specific solder see my photos after my first test :

Work perfectly with low temperature Poss: - no residue after welding - low temp - no clean Con : no lead : specific solder see my photos after my first test :

Work perfectly with low temperature Poss: - no residue after welding - low temp - no clean Con : no lead : specific solder see my photos after my first test :

This product is perfect for SMD, through hole or heatsink soldering. The consistency is perfect, not runny but sticks to the board and component, melts and flows ideally, and whilst these are quite large needles, you can easily change the needle for one to suit your board and smd sizes. The nozzle unscrews and screws back on so saving the product from drying out, and the plunger pushes against a internal stopper under the red cap, so it doesn't dry out there either, the needles are short so you don't waste much of the product (as you can't draw it back into the syringe like you can a regular syringe, but I don't care!). It leaves a little flux residue, but other than that this is by far the best of the several pastes and paste laying products I've used over the past few years. It withstood the temperature of the heat sink getting too hot to touch, the board I did passed it's shakedown tests, and whilst I can't comment on the shelf life, but stored correctly this product should do better then the paste sold in pots

This product is perfect for SMD, through hole or heatsink soldering. The consistency is perfect, not runny but sticks to the board and component, melts and flows ideally, and whilst these are quite large needles, you can easily change the needle for one to suit your board and smd sizes. The nozzle unscrews and screws back on so saving the product from drying out, and the plunger pushes against a internal stopper under the red cap, so it doesn't dry out there either, the needles are short so you don't waste much of the product (as you can't draw it back into the syringe like you can a regular syringe, but I don't care!). It leaves a little flux residue, but other than that this is by far the best of the several pastes and paste laying products I've used over the past few years. It withstood the temperature of the heat sink getting too hot to touch, the board I did passed it's shakedown tests, and whilst I can't comment on the shelf life, but stored correctly this product should do better then the paste sold in pots

This product is perfect for SMD, through hole or heatsink soldering. The consistency is perfect, not runny but sticks to the board and component, melts and flows ideally, and whilst these are quite large needles, you can easily change the needle for one to suit your board and smd sizes. The nozzle unscrews and screws back on so saving the product from drying out, and the plunger pushes against a internal stopper under the red cap, so it doesn't dry out there either, the needles are short so you don't waste much of the product (as you can't draw it back into the syringe like you can a regular syringe, but I don't care!). It leaves a little flux residue, but other than that this is by far the best of the several pastes and paste laying products I've used over the past few years. It withstood the temperature of the heat sink getting too hot to touch, the board I did passed it's shakedown tests, and whilst I can't comment on the shelf life, but stored correctly this product should do better then the paste sold in pots