MK7 MK8 Dissipador de calor 40MM x 40MM x 11MM para acessórios para impressoras 3D
Uma parte da revisão foi traduzida automaticamente.
Muy buen producto, Gracias BANGGOOD.
The center hole gives plenty of clearance for the motor axle if needed. Note that there are only 2 holes pre-drilled and you may want to drill more for mounting with screws. I used 2 M3 rods that are screwed to the motor on one end and tightened with nuts over a 40mm fan on the other end. I recommend applying thermal paste between the Heat Sink and the motor for best performance.
These heatsinks fit perfectly on my NEMA 17 motors. I drilled 2 holes to fix them with threaded rods between 40mm fans and the motors.
Kommen wie auf den Bildern zu sehen. Ist nicht wirklich notwenig aber fuer den Preis...
Nice
The holes in the heat sink don't leave enough room to put a screw head in. Mod needed to make it fit.
Passt perfekt an einen Nema 17 Stepper Motor. Achtung nur für die Rückseite. Vorderseite ist die Mittenbohrung zu klein und auch der extruder im weg.
Livraison lente mais produits conforme
great heat sink
Just the right fit for my Ender 3