floris1200Escreveu 2618 dias atrás.I use this module in taranis transmitter.
it binds with cheerson cx10.
it didn\'t bind with Eachine E010.
I after analyse problem i discovered bad NRF24L01 module under the foam padding.
I emailed banggood service with my problem but the say they have \'good product\'.
I even asked if i can have the firmware what is flashed in the module but they say \' no firmware by this product\'.
so i tried to make a backup of the firmware in the atmega328 but the bastards put the lockfuse on.
so no backup of the firmware.
The module runs on the formware from goebish.
i reloaded it even with changing channels to check my work.
still no binding with E010.
finally i reordered on aliexpress a few nrf24l01 modules.
i replaced the nrf24l01 module and tadaaaa
instantly it binds with my E010.
sorry for the bad pictures
but the idea is to show the faulty nrf24l01 module wich has raw die chip with some kind of exposed silicon.
the good module as i replaced has a proper ic package.
so if you are not able to bind with your eachine
Para DartFeider14/01/2017I connected to the equipment Flysky FS-I6. Quad Eachine H8 Mini
Para Pagan14/12/2016Attention! The product works with certain settings.
Settings for FlySky FS-TH9S (Turnigy 9X, iMAX-TH9X):
1)SYSTEM SETTING \ TYPE SELE \ HELI \ HELI-1
2)2) SYSTEM SETTING \ MODEUAT \ PPM
3)SYSTEM SETTING \ STICK SET \ MODE 2 (Question about “REVERSE THR?” press the exit button)
4)FUNCTION SETTING (1\2)\ E. POIN (changing all on 120%)
save settings \ switch off \ plug-in module \ binding \ go fly
Для русскоязычных пользователей. Создаете модель с