mece
- Meu conteúdo
- Todas as mensagens
- Comentários
- Comentários
- respostas
- Questões
respostas
Q: just wondering if this will work for the tarantis X9D plus remote? Thankyou
perguntado por kanzezol sobre 2019-10-07 02:31:26
mece It's definitely a cmos camera. I didn't actually notice that it said ccd I just assumed it was cmos since pretty much all new micro cameras are cmos. It's M12 lense
Útil (1)
Q: can a 3 inch prop fit this frame?
perguntado por berkeokur1022 sobre 2018-05-02 11:45:46
mece No. it's made for 2.5 inch props
Útil (0)
Q: Where should I connect video-in and video-out, coming from FPV camera, for betaflight OSD?
perguntado por thebigfox sobre 2018-03-15 10:31:18
mece The for pads on one edge that are separate from the others is for video. They are labeled. if you look at the board USB port down, they are on the right side. From top to bottom Video In, Video out, +5V, Ground. The ground pad is square and the others are round.
Útil (0)
mece This is for flashing firmware on receivers and external modules. If you have an X9D you can just use the radio to flash the receivers so you don't need this unless you want it for convenience.
Útil (0)