Ianlaing1
- Meu conteúdo
- Todas as mensagens
- Comentários
- Comentários
- respostas
- Questões
respostas
Q: well this work with happy model elrs receivers too, or just yours?
perguntado por Scotty2Quady sobre 2021-07-17 09:16:40
Q: Will this work with x8r receiver?
perguntado por Colin Doughty sobre 2021-06-19 16:02:35
Ianlaing1 no
Útil (0)
Q: is it suitable with Jumper t-lite transmitter?
perguntado por KarloBalboa sobre 2021-04-19 14:37:48
Ianlaing1 if you have a 3d printer then no
Útil (0)
Ian The Post for the tx805 json from github will work at rated power the TX805S.. ignor the fact it say 800, its actually providing the full at 1.6w at the 4th power setting...
Útil (0)
Q: do you have a direct drive version (not Bowden Long range but direct drive for bondtech prusa setup)
perguntado por Paul Cole sobre 2019-03-27 20:40:45
Ian depending on setup with work with say a titan extruder which uses a short PTFE tube ..
Útil (0)
Q: where can I plug SUMD (graupner sbus) ?
perguntado por aircraftfire07 sobre 2019-03-06 15:49:56
BG451864550 rx3
Útil (0)
Q: will this work on normal r9m? like r9mm normal does?
perguntado por FTJ sobre 2019-09-28 11:03:36
ian.laing I was not able to use this receiver with the non access R9M module :( rather buy non access receivers for older modules.. Maybe someone else has managed to use this receiver in with r9m TX..?
Útil (0)
Q: Can't seem to find a termination plug that fits. Could you link one?
perguntado por rippst sobre 2018-11-30 04:56:44
ian.laing there appears to be no dummy 50 ohm available for these. Makes them useless. Rather buy the other antenna that have male not female like these...
Útil (0)
Ianlaing1 will work with any expresslrs flashed hardware.
Útil (1)