mike_o
- Meu conteúdo
- Todas as mensagens
- Comentários
- Comentários
- respostas
- Questões
respostas
mike_o 2-6S This one has the wide range SMPS
Útil (0)
Q: Do these work straight off 12V, or do they need some sort of voltage booster?
perguntado por Hasi0 sobre 2020-01-25 12:52:01
mike_o Yes, they need a "ballast" unit, as they operate on 80-90V DC and an initial high voltage (kilovolt!) kick-start to get the ionisation going.
Útil (0)
mike_o Oh, you poor thing! 2 pcs are included in the deal.
Útil (0)
mike_o It's a brushed motor. A brushless motor will normally have 3 terminals, this one only has 2.
Útil (2)
mike_o I use a 2836mm (outside diameter) 1150KV motor with a Graupner 8x5 Eprop on 3S. I get below 100mAh/km which corresponds to 75mAh/km at 4S. Still plenty of thrust for launch and climb.
Útil (3)
Q: hi, the material of this plane is compatible with cyanoacrilate glue?
perguntado por hendrick sobre 2019-08-18 15:56:09
mike_o Yes, the EPO is OK with CA glue. Actually, CA is the best for EPO, many established manufacturers recommend using CA for assembly.
Útil (1)
Q: Has anyone connect OLED screen, this requires SCL, and SCA.. Does this board have this options?
perguntado por AndrewY sobre 2019-03-25 04:14:44
mike_o This board does NOT have SCL-SDA, so no OLED, ext compass etc
Útil (0)
mike_o Yes, just set serial protocol to "10",
Útil (0)