JeffKnickelbein
- Meu conteúdo
- Todas as mensagens
- Comentários
- Comentários
- respostas
- Questões
respostas
JeffKnickelbein I have cut up to 10mm balsa, 3mm light plywood, MDF up to 4mm. The thinner wood cuts in a single pass. The cheaper 6mm pine plywood does not cut so well.
Útil (0)Q: What is the total measurement of the area that can be lasered?
perguntado por BG184779192 sobre 2022-09-14 12:19:05
JeffKnickelbein It does 400mm x 410mm, although I have not tested the maximum area.
Útil (0)
Q: hello Does this item fit helicopter ALZRC Devil 420? its the same 420mm
perguntado por JeepB sobre 2022-04-13 04:20:35
JeffKnickelbein It will be fine, the pitch range may change slightly.
Útil (1)
Q: bom dia, este servo e aprova d'água?
perguntado por MidDudu sobre 2022-03-19 19:37:08
JeffKnickelbein This servo is splash proof, but not waterproof, so don't used it in a boat unless it is in a water tight container.
Útil (0)
JeffKnickelbein I think it supports up 64GB SD cards, but you don't need that much data.
Útil (0)
JeffKnickelbein You need to create a Wunderground or similar account to store the data, which is then accessible by your phone. The weather station posts the data to the cloud for storage.
Útil (2)
Q: Do I need to install the drivers?
perguntado por ghost sobre 2020-11-10 08:58:47
JeffKnickelbein That depends on the operating system. If you have Arduino dev environment, the drivers are included.
Útil (0)
JeffKnickelbein No, the frame is aluminium.
Útil (0)