respostas

Kobie The little unit where the cameras plug in, have a plug that you connect to your RX (Receiver). A channel on your transmitter can then be assigned to switching between cameras.

Útil (0)
Enviar
respostas (2)

Q: can it be used to control a speed drill or grinder?

perguntado por BG514437481 sobre 2022-09-25 02:27:59

Kobie If it is DC, battery powered yes. If it is AC, mains powered, NO, it will not work, you will let that smoke out that all electronics work with.

Útil (0)
Enviar
respostas (2)

Q: what is the difference between the "10M" & the "10M with Pin"? Thank you!

perguntado por NH_4X4JEEP sobre 2022-02-15 22:33:21

Kobie Probably just with or without the 3 connecting pins CN1 installed or not.

Útil (1)
Enviar
respostas (2)

Q: Hi I would like know if i can see it in U. S. Foot or inches

perguntado por BG839203714 sobre 2021-03-06 16:18:20

Kobie The tape is clearly marked in metric and inches. The laser measuring can also be selected to read in metric or inch

Útil (0)
Enviar
respostas (8)

Q: Can it convert also to a lower voltage, e.g. from 12V to 5V?

perguntado por BG248255361 sobre 2021-11-12 01:56:07

Kobie I have not received mine jet, but this is a "boost" coverter. It should "step up" the voltage and I do not think it will allow a "buck", "step down action. Obviously with Ohm's law in mind input Watt and output Watt will be near the same less a bit of losses. There are some "buck boost" converters available that will go both ways. for example DD39AJPA 2 in 1 20W Boost Buck Dual Output Voltage Module 3.6-30V to ±3-30V Adjustable Output DC Step Up Step Down Converter Board

Útil (0)
Enviar
respostas (1)