Todas as mensagens

Q: what is the maximum ampere hour of this BMS

perguntado por BG453216433 sobre 2020-11-19 11:23:50

Samppa78 Contact customer support for more info

2022-11-21 01:05:50 Útil (0)
Enviar
respostas (2)

Q: Is this compatible with the Ender 3 Max?

perguntado por BG535361435 sobre 2022-01-29 11:35:57

Samppa78 Yes.

2022-11-21 01:05:18 Útil (0)
Enviar
respostas (2)

Q: is possible cut the profiles regarding to my size needs?

perguntado por Eddie Piazza sobre 2020-09-18 06:47:53

Samppa78 Contact customer support

2022-11-21 01:05:16 Útil (0)
Enviar
respostas (2)

Samppa78 As long as the battery pack doesn't exceed tester maximum voltage then its okei. However it will take many hours to test a big battery pack. Notice ohm law when you test battery's, depending on the set voltage you will be able or not to pull 180W. This is a maximum for this tester and you can burn mosfet. Run this device at max 150W and before use remove cooler and make sure that thermal compound is present.Just to be safe replace for better quality thermal paste.

2022-11-13 06:36:34 Útil (0)
Enviar
respostas (1)

Q: Can I use this for my mini 7 egg incubator?

perguntado por BG541355221 sobre 2022-09-06 05:13:37

Samppa78 If the fan specs are the same and fan model then why not?

2022-11-13 06:30:08 Útil (0)
Enviar
respostas (1)

Samppa78 This is a part cooling fan.The same that you will find on any Ender series 3d.Intended to cool printed parts during printing process. Its a blower fan.

2022-11-13 06:27:49 Útil (0)
Enviar
respostas (4)

Q: Hello! Thread size M10 step 1?

perguntado por Yurik-RC sobre 2018-05-28 01:21:52

Samppa78 Yes.

2022-09-02 11:47:57 Útil (0)
Enviar
respostas (2)

Q: Does it have anyway of locking??

perguntado por BG404864324 sobre 2022-08-13 11:13:59

Samppa78 No key locking but a few holes on upper and lower case that you can pit some key lock if you want.

2022-09-02 11:47:40 Útil (0)
Enviar
respostas (1)