Todas as mensagens

Q: Can this drone carry GoPro underneath? Can it still fly if I attach a gimbal?

perguntado por brybrian sobre 2019-02-22 09:07:28

reefdiver youcan get a base for over the drone. for under I didn't find.

2020-01-11 04:21:14 Útil (0)
Enviar
respostas (1)

Cambes Busca en youtube Gps -> fc Gnd ->gnd + -> 5v Rx -> tx Tx -> rx

2020-01-02 02:45:52 Útil (0)
Enviar
respostas (1)

Q: can this work for controlling gimbal on drone?

perguntado por brybrian sobre 2019-04-17 04:42:14

Mech Yes it can, been using it for a gimbal for months

2019-10-29 03:44:00 Útil (1)
Enviar
respostas (2)

Q: What frequencies can it transmit?

perguntado por brybrian sobre 2019-05-04 09:17:52

elricotti transmits in 5ghz on 14 channels

2019-07-21 06:52:51 Útil (0)
Enviar
respostas (1)

Q: Can you run a 4s battery on this controller?

perguntado por BrysonBarney sobre 2018-01-14 12:17:32

brybrian I tried a 4s on this board and it blew, so I would not recommend

2019-05-19 03:16:31 Útil (0)
Enviar
respostas (4)

Q: Will it work with FlySky i6x transmitter?

perguntado por Serguey sobre 2018-02-27 02:59:49

brybrian Yes, it does work with flysky i6x. I use A8S receiver that comes with transmitter

2019-05-05 02:52:15 Útil (0)
Enviar
respostas (4)

Q: binding on syma x8c

perguntado por Ana sobre 2018-09-13 02:22:05

brybrian where to buy syma x8c?

2019-04-18 09:22:27 Útil (0)
Enviar
respostas (3)

Q: Does this work with a tarantula x6 and its battery? Its a 2S

perguntado por GioESA sobre 2018-10-28 12:57:35

brybrian I use this gimbal on tarantula x6 following tigerRC reviews on YouTube. It works better with a separate battery like a 300mAh 7.4v battery. I get short flight time if it draws from the quadcopter battery

2019-04-17 06:19:55 Útil (0)
Enviar
respostas (1)

brybrian Does this combo work? Can it be controlled by FrSky FS-ix6 and 8ch receiver?

2019-04-17 06:16:16 Útil (1)
Enviar
respostas (7)

brybrian what size hexacopter does this work for?

2019-04-16 06:19:54 Útil (0)
Enviar
respostas (5)

brybrian I think this would work for a multicopter. The specs suggest it only needs a 30A ESC to function with 1045 props and it will generate 1310g of lift. So on a hexacopter that would be a total of 6kg lift which should be good enough

2019-04-15 01:52:08 Útil (1)
Enviar
respostas (6)

brybrian Whatsize quadcopter is that?

JiriKlemenc 2018-04-26 15:21:58
3
Comentários (1)