Todas as mensagens

Q: Output anti-reflux..????

perguntado por BG533216384 sobre 2020-06-14 12:57:01

lanafina452 The input interface uses screws to secure wires from the Power Supply module. This interface can also be removed to allow the incoming wires to be soldered directly to the PCB.

2020-10-30 04:30:52 Útil (1)
Enviar
respostas (5)

Q: Why Bangood does not publish the reviews on this item?

perguntado por Carlos sobre 2019-09-15 03:57:50

BG533216384 I don't know but I bought it and it's very useful cause it shows that parameter on the display even for power factor. 👍

2021-05-20 10:10:51 Útil (0)
Enviar
respostas (1)

BG533216384 You can't turn it off. It doesn't matter and just like many appliances are always on!! It's very easy to connect via Bluetooth, if not just reset your cellphone Bluetooth sitting and paired again.

2021-05-20 10:09:01 Útil (0)
Enviar
respostas (4)

Q: so can you use rca cable or is it just a bugger aux cord?

perguntado por BG111725210 sobre 2021-05-20 09:36:40

BG533216384 No it's only by 3.5mm jack Aux or by Bluetooth, and be careful it's need to add pre amplifier!!!!

2021-05-20 09:56:18 Útil (0)
Enviar
respostas (3)

BG533216384 The manual only can be activated if you go to your pc it's not available on the smart phone 👍

2021-02-05 10:35:19 Útil (0)
Enviar
respostas (2)

BG533216384 It's very easy first of all mount the magnetic piece to the front spoke and tighten it properly then mount the sensor to fork (try to mount it side by side to sense the magnet each turn) by zip ties which included, then connect the jack to speedometer properly. Mount the press button to handlebars and zip tie the wire as you go to the unit and connect the wire to usb input (at the back of the unit)

2021-01-10 07:29:13 Útil (0)
Enviar
respostas (2)