Todas as mensagens

Q: 災害の時、自宅用、酸素の機械に対応できますか?

perguntado por BG463413162 sobre 2022-04-10 06:34:15

Lucifer No way. You need a Victron inverter if you want reliability.

2023-02-02 03:26:23 Útil (0)
Enviar
respostas (1)

Q: Quisiera saber O q m expliquen q es envió desde CN?

perguntado por BG523754224 sobre 2020-04-27 04:21:24

Lucifer Sent from CN means it's sent directly from the Chinese manufacturer.

2022-11-17 12:42:14 Útil (0)
Enviar
respostas (2)

Q: Can the output power be turned down?

perguntado por Lucifer sobre 2022-10-03 02:02:36

chinatronic I did not find an option that would allow to throttle the performance. However, the performance of these devices is usually stated much too high. An example is a device that is advertised with 8 watts Effectively, 3 possible transmitters frequency ranges 5+2+1 = 8 watts were added together

2022-10-23 03:11:33 Útil (1)
Enviar
respostas (1)

Q: it's written that it can go 100km/h in the description, how can you unlock that ?

perguntado por BG453217153 sobre 2022-08-29 10:17:05

Lucifer Top speed is limited by voltage. 48v battery is about 40-50kph. 60v battery is about 50-60kph. 72v battery is about 70-80. 84v battery is about 80-100kph. If the controller can't handle more than 60v then you're limited to about 60kph.

2022-09-07 07:37:10 Útil (0)
Enviar
respostas (2)

Q: CAN IT FIT FOR DATSUN GO PLUS 2018 MODEL

perguntado por Julian sobre 2018-09-28 03:56:12

BG453716393 It would fit all 12v vehicles.

2022-04-23 09:53:12 Útil (0)
Enviar
respostas (1)

BG453716393 Both will accelerate at roughly the same rate but the 48v will have a higher maximum speed. But this is also dependent on the batteries being able to supply enough amps.

2021-12-07 01:59:13 Útil (0)
Enviar
respostas (4)

BG453716393 You shouldn't have to change any capacitors, a car battery should provide enough current for 0.2mm. Just keep the battery cables short and use thick cables like jumper leads to connect to the battery. The 8mm width changes nothing - they can be 800mm and it'll still work the same. This is a spot welder so it welds a small dot where you hold the two probes against the nickel strips.

2021-10-09 04:56:21 Útil (1)
Enviar
respostas (1)