Todas as mensagens

RC_Dude Even if the voltage recovers it does not shut da f**k up and beeping like a hell at 100+dB and anoying everyone around untill you unplug it. However it is a very useful device for long and safe use of your batteries. One of my such device broke down and no longer works probably got wet when I sailed the rc boat.

2020-11-29 11:24:06 Útil (1)
Enviar
respostas (2)

Zeemax It will buzz constantly until you disconnect it

2020-10-20 09:41:23 Útil (1)
Enviar
respostas (2)

Link440 If you order the TX18S Lite you need a external modul if you want to fly ( FlySky AFHDS ) JP4IN1 Module : https://fr.banggood.com/custlink/vDDEp1iG8t

2020-09-25 11:41:35 Útil (2)
Enviar
respostas (2)

Neslarc They are for 3.7V 1S lipo battery brushed ESC. I wouldn't exceed 5V. Don't know what the amp load is but it is very low. You can get 20 minutes flying on a 250 mAh 1S battery.

2019-10-04 06:10:48 Útil (0)
Enviar
respostas (2)

Q: whats the max thrust?

perguntado por eltee sobre 2019-04-29 02:26:01

Neslarc Measured unscientifically, the 820 has approximately 2 ounces of thrust. Used in a 2.5 ounce slow flier indoor airplane it needs less than half throttle to cruise and a good climb at full throttle.

2019-10-04 05:59:51 Útil (0)
Enviar
respostas (2)

Q: can I use this prop for motor mounted on the back of the plane?

perguntado por RONAK10 sobre 2018-02-27 03:01:24

Neslarc Yes. Always mount the propeller so the numbers on the blades face towards the front of the airplane. You will have to reverse the direction of the motor rotation.

2019-08-11 08:31:17 Útil (0)
Enviar
respostas (2)

Q: With which protocol it's works?

perguntado por racz96 sobre 2019-06-13 04:01:44

Neslarc It uses Flysky AFHDS protocol.

2019-07-10 07:19:24 Útil (0)
Enviar
respostas (1)

Q: is it compatible with the flysky fs-I6?

perguntado por Adryanvdb sobre 2018-10-18 11:49:02

Neslarc Yes. It binds to Flysky FS-i6 transmitter if you switch to AFHDS protocol. You have to bind to the transmitter every time you change the battery.

2019-07-10 07:17:53 Útil (0)
Enviar
respostas (2)

Q: What is the motor shaft diameter?

perguntado por Neslarc sobre 2019-02-08 07:24:43

Jonnie 3.17mm

2019-02-27 08:15:40 Útil (2)
Enviar
respostas (1)