Todas as mensagens

Q: How can i wire SPort/FPort from R9mm?

perguntado por BG571554046 sobre 2020-11-14 08:11:32

RISCORIX no te sabría decir la verdaf

2022-08-01 03:05:27 Útil (0)
Enviar
respostas (2)

BG164934541 Den Deckel abschrauben und den Haptic Motor mit Sekunderkleber fixieren.

2022-02-11 09:13:29 Útil (0)
Enviar
respostas (3)

oacilamaf Epprom memory is running out of space. Most likely you have too many models saved. Search your model list to look for unused models and delete to gain some memmory. you can back up the models in opentx companion. If you don't delete models the message will show everytime you add a model or change a models setup.

2021-12-01 03:28:14 Útil (0)
Enviar
respostas (2)

Q: How to wire Frsky FPort?

perguntado por BG571554046 sobre 2021-05-03 07:52:45

AERR fport from rx, too tx on uart your using

2021-05-06 09:34:14 Útil (0)
Enviar
respostas (1)

Q: Is the connection possible with R***** MHz or only with 900 MHz?

perguntado por Marcel sobre 2020-11-02 02:47:16

alessandrojun Yes it works with R9M with ACCST or flex protocol.

2020-12-24 07:40:30 Útil (0)
Enviar
respostas (2)

agentgizmo Slot is slightly misaligned. The SD card has a slight lip on it too which can hang it up. I took a small screwdriver and gently coaxed it out. After that I filed the slot a bit and it's perfect now.

2020-11-30 01:36:56 Útil (2)
Enviar
respostas (2)

Q: Is it possible to flash flex firmware for r9m?

perguntado por schlotz23marcel sobre 2019-10-24 06:06:45

Craatz nosorry

2019-11-29 07:14:18 Útil (0)
Enviar
respostas (1)