Todas as mensagens

ruthart It generates a signal which can be used by your main board if so equipped. It would stop the print, record the position and sound the alarm. You may have to modify the firmware for this to work.

2021-09-24 07:06:50 Útil (0)
Enviar
respostas (1)

Q: how big is the diameter on the hole

perguntado por BG782340512 sobre 2021-04-30 11:34:44

ruthart The hole is 5mm diameter.

2021-04-30 12:52:47 Útil (0)
Enviar
respostas (2)

Q: Does this board have a programmer on board?

perguntado por trypesdg sobre 2021-03-28 08:22:52

ruthart It has a boot loader. If you write a program in the Arduino IDE or PlatformIO you can upload it through the USB port.

2021-03-28 09:12:48 Útil (0)
Enviar
respostas (4)

Q: How bad is the backlash on these?

perguntado por Bgsto sobre 2021-02-23 08:36:59

ruthart Backlash is undetectable. But keep in mind that there is a 64 times speed reduction gear inside so it is quite slow.

2021-02-24 07:05:03 Útil (1)
Enviar
respostas (4)

Q: Will it work with tmc2208 stepper driver?

perguntado por BG531791042 sobre 2021-02-16 12:49:09

ruthart Yes. Go to reprap.org and check out the wiki info for this board.

2021-02-16 01:50:29 Útil (0)
Enviar
respostas (1)

Q: WHAT HOSE SIZE ARE THE INLET & OUTLET ???

perguntado por BG171125920 sobre 2020-07-04 12:14:40

ruthart The thread is 0.5 inch pipe thread (od 20mm 14 threads per inch). the id is 12 - 13mm.The best fit is probably 0.5 inch hose.

2020-07-05 09:42:43 Útil (0)
Enviar
respostas (1)

Q: What is the current draw of this magnet

perguntado por BG161715491 sobre 2020-06-17 01:03:45

ruthart According to the specs 110mA.

2020-06-18 11:31:14 Útil (0)
Enviar
respostas (1)

ruthart Use a knife with a strong blade and pry it open at the corners. You have to apply some force but I was able to open it. The LED is next to the battery area.

2020-05-15 10:28:02 Útil (0)
Enviar
respostas (2)

Q: What stepper motor will this work with?

perguntado por ancsvc sobre 2020-05-06 01:21:20

ruthart Any nema 17 stepper will work. You don't need high torque.

2020-05-06 08:34:18 Útil (0)
Enviar
respostas (1)