Todas as mensagens

Graylag Technically yes, but I do not recommend it. It uses only basic "slow" PWM control, which is fine for a car, boat or slow airplane, but will not be sufficient for more nimble quad.

2021-09-22 02:52:33 Útil (0)
Enviar
respostas (3)

Q: Does is work with Flysky FS-i6 ?

perguntado por TheProud sobre 2021-08-23 03:38:25

Graylag It does not with stock FS-i6. You need to flash alternative firmware to radio for it to work.

2021-08-23 04:14:03 Útil (1)
Enviar
respostas (4)

Q: wil it work with ev100 goggles?

perguntado por STEVE sobre 2021-02-11 05:45:49

Graylag Workin what way? This is intended to be connected to phone or computer, where it acts as "webcam", showing FPV video. It does have analog video output, so you could in theory connect it to AV input of EV100, but you might have issues with latency or other things as it is not intended as "primary" receiver.

2021-02-15 09:13:01 Útil (0)
Enviar
respostas (1)

Q: Can the lens be used on the Eachine EV800D? Thanks

perguntado por alessandro1958 sobre 2020-12-19 10:55:36

Graylag No,EV800D does not have fixing points for this lens.

2021-02-15 09:08:14 Útil (0)
Enviar
respostas (1)

Graylag no, it can not be used together. Syma S-107 does not even use radio transmitter but IR transmitter, completely different technology.

2020-11-20 12:51:24 Útil (0)
Enviar
respostas (1)

Q: Will this work with the radiomaster tx16s radio? If so can you please explain

perguntado por BG171418368 sobre 2020-11-17 08:24:47

Graylag Yesit will. Radiomaster tx16s has internal multimodule which is capable to connect to (among others) AFHDS 2A receivers. Just select FlSky2A and bind as you normaly would, it will work.

2020-11-19 02:45:13 Útil (0)
Enviar
respostas (4)

Q: is this. compatible with Matek f411?

perguntado por RCAirplaneDude sobre 2020-11-11 07:17:19

Graylag Yesit is. As well as with any other controller with standard 5V or 3,3V UART.

2020-11-11 07:24:37 Útil (1)
Enviar
respostas (6)

Graylag FlySkyand FlySky compatible receivers only (not Spektrum) Binding procedure is 1. set receiver into bind mode either through button, or through bind cable 2. switch off transmitter, hold bind button on transmitter and switch transmitter on 3. For telemetric receivers you are done. For not telemetric receivers switch transmitter again off and on (without holding down the button).

2020-09-26 01:19:35 Útil (0)
Enviar
respostas (1)

Q: Does it serve to increase the distance from the Drone? how much does it increase?

perguntado por KUBIAK542313203 sobre 2020-09-07 09:01:16

Graylag Itdoes not serve to increase the distance from a Drone. This is receiver for analog video over 5,8 GHz, which is commonly used on drones and FPV planes - it serves exactly same purpose as FPV googles and has no significant advantage over regular FPV googles except for the form.

2020-09-15 12:29:05 Útil (0)
Enviar
respostas (1)

Q: What's the pin header spacing? 2.54 mm ? Thx

perguntado por BG535364812 sobre 2020-09-07 06:00:54

Graylag yes,it is regular 2,54 mm. You can directly connect servo connectors to servo header etc.

2020-09-15 12:22:47 Útil (0)
Enviar
respostas (1)

Q: Will this work with my EV800D?

perguntado por Bushko sobre 2020-07-29 02:56:37

Graylag Yes it will. Just make sure to buy SMA version. On other hand, don't expect much improvement over stock antennas. Omnidirectional Pagoda has similar performance to stock cloverleaf. And while Triple Feed Patch directional antenna has advantage over stock linear panel antenna in wider beam width and circular polarization, stock panel antenna still outperforms it in gain as long you keep your drone in its narow beam, even when you count losses due to not having circular polarization.

2020-08-21 05:27:40 Útil (1)
Enviar
respostas (2)

Q: does it have the new access protocol for the newer frsky access receivers?

perguntado por Jermie sobre 2019-08-23 02:17:19

Graylag No,it does not and might not ever have. ACCESS protocol is still new and crucial information about it is missing, including if it can or cannot be implemented. See DIY-Multiprotocol-TX-Module github and related descussion for more information.

2020-01-07 04:04:58 Útil (0)
Enviar
respostas (2)