Todas as mensagens

Q: I want to know if it's compatible with OpenTX ?

perguntado por popad sobre 2023-11-19 05:27:16

BG511344559 normalement oui, mais étant donné que ce dernier n'est plus suivi par des mise a jour régulières, tous le monde c'est tourner vers sont fork EDGETX

2024-05-18 04:52:23 Útil (0)
Enviar
respostas (2)

Q: SD card is included ?

perguntado por popad sobre 2023-11-23 01:59:53

Will Dunn Yes and card comes installed

2023-11-26 02:32:17 Útil (0)
Enviar
respostas (1)

popad Link generate an error: "HTTP ERROR 431". Please, give the right link for pdf manual.

2023-10-28 03:02:30 Útil (1)
Enviar
respostas (3)

Q: Is compatible with Jumper 4in1Tx module ?

perguntado por popad sobre 2019-03-18 08:17:08

BG101193121 No

2021-11-03 06:07:32 Útil (0)
Enviar
respostas (2)

Q: Can be bind with Jumper T12 ?

perguntado por popad sobre 2021-02-06 10:41:17

Richard I bind them to a Jumper T12 Pro transmitter, which has an inbuilt 4-in1 Multi-protocol module. With a T12 (not Pro) I think you have to put a 4-in-1 module into the bay on the back of the TX.

2021-10-15 08:35:24 Útil (0)
Enviar
respostas (2)

Q: Work with Jumper 4-in-1 Tx module ?

perguntado por popad sobre 2019-11-15 01:48:49

absinth84 yes.it works well

2021-08-26 10:28:27 Útil (0)
Enviar
respostas (1)

Q: How to enable break ?

perguntado por popad sobre 2021-08-21 12:32:36

HazzahFPV Using an Arduino nano or a flight controller you can connect to the ESC via the BlHeli Suite v16.x on your computer. There you can then turn on "Brake on stop". This will short all three motor-phases to ground when throttle is zero, acting as a brake.

2021-08-22 02:55:26 Útil (0)
Enviar
respostas (1)