simon
Q: Hi can anyone help,got everything set up but when I power it up with props off to test motors the slight rise on the throttle stick the motors spin up and go to full throttle and the stick then will not bring the speed down I have to disarm,all other stick movements work OK just throttle,some forums say this is normal with the props off on the cloud reptile,not tried with props on yet due to it shooting Ver mais
perguntado por simon sobre 2020-06-06 06:16:08
Templewas For more information visit techexperience.net/go/drones
2020-06-23 03:38:48 Útil (0)
Xuthus You can describe your SD card problem to the customer service in detail.
2019-10-30 03:30:48 Útil (0)Q: Ive purchased one pretty good,can you run more than one camera on the same account.
perguntado por simon sobre 2019-09-09 13:38:08
ouxinke Yes, there are no restrictions
2019-09-10 01:45:57 Útil (0)We sincerely invite you to subscribe to the Invite Answer email!
If you subscribe, we will invite you via email to answer questions people have about products. By subscribing you’ll also earn the "Helpful Badge"! You can unsubscribe at any time on the privacy settings page.
Help others and be happier!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
BG203725422 Yes, you may need new stepper motor as Creality push fit extruder gears and you also need to adjust e-step values
2022-05-30 11:58:44 Útil (0)