ahx1314
Q: Can I use TPU filament on this printer? Thank you
perguntado por ahx1314 sobre 2021-03-31 10:07:00
lightpixel you can resource in betaflight the UART1, that´s used by stock for wifi function of the FC. Resource it to LED pad to RX from GPS and S5 pad to TX from GPS. But then you have to setup the vtx manually... Ver mais
2021-04-26 07:06:55 Útil (4)Q: Can I bind jumper t-lite jp4 with frsky xm+? There is no problem with actual accst frsky receivers?
perguntado por ahx1314 sobre 2021-04-21 07:48:54
BG211543421 I have this setup and can't find instructions to do it
2021-12-08 05:13:33 Útil (0)Q: what firmware (accst) does it have? 1.xxx? 2.xxx?
perguntado por ahx1314 sobre 2021-01-01 09:13:18
uozkan It is frsky d8. works with fcc accst radios.
2021-09-07 15:03:37 Útil (0)Q: hi, can I run 4s batteries? there's something I need to change like PIDs Profiles? thank you
perguntado por ahx1314 sobre 2020-12-30 06:02:09
Sebastian you can buy the 4s version that you don't need to change anything. The motors are specified for 6s batteries, you cannot change that.
2021-01-04 05:27:33 Útil (1)Q: Hi, can I put 4s batteries? there's something that I need to change like PIDs Profiles ?
perguntado por ahx1314 sobre 2020-12-30 05:57:45We sincerely invite you to subscribe to the Invite Answer email!
If you subscribe, we will invite you via email to answer questions people have about products. By subscribing you’ll also earn the "Helpful Badge"! You can unsubscribe at any time on the privacy settings page.
Help others and be happier!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
gustafpeter330 yes you can but make sure to not go over 230°C because of 5he tubing in the printhead.
2022-03-17 13:18:00 Útil (0)