BG234854340
Q: this gps have 6 wires, where shouldt i solder the scl and sda wires on the FC-10 Board??
perguntado por Atilla sobre 2021-02-06 17:10:30
Bimmermb those SCL and SDA are for magnetometer and are optional if you have them.
2022-11-11 17:04:27 Útil (0)
Q: i have a problem, i fly this motors since last year in my quad, they worked very well, but this year i take it for the first flight i recognize a big problem. i use 3 blade 5040 prop an 4s lipo, after take of the battery voltage drops from 16.8 v to 15.8v in 3 seconds, and the hole battery is down to 15volts in one minute, and when i go a little full throttle, the voltage drops under 14 volts and the Ver mais
perguntado por Atilla sobre 2022-04-14 10:31:54
Nc_Mike Try to restore your tuning on the quad, or install the latest firmware of betaflight and run defaults pids. check if it solves the problem.
2022-05-31 18:26:42 Útil (0)Q: please tell me, can i connect the DJI air unit to this board to reach osd??
perguntado por Atilla sobre 2021-01-12 11:06:10
ItsRagnarok It's normal...what capacity does your battery have tho?
2022-04-27 02:21:44 Útil (0)
Q: the prop diameters on the list, tell me are they two blade or 3 blade props??
perguntado por Atilla sobre 2022-04-16 15:38:33
BG193216481 my guess is 3 blade.
2022-04-22 15:35:25 Útil (0)
karsten230 1.4
2021-11-19 05:27:19 Útil (0)Q: hi, can somebody tell me, how to set this plane on my TX16S transmiter?
perguntado por Atilla sobre 2021-08-07 10:34:19
käsekuchen Check the manual linked in the product page. You need 6 channels, no special mixes required, although the rudder channel does not do anything because there is no rudder.
2021-08-07 16:15:47 Útil (1)We sincerely invite you to subscribe to the Invite Answer email!
If you subscribe, we will invite you via email to answer questions people have about products. By subscribing you’ll also earn the "Helpful Badge"! You can unsubscribe at any time on the privacy settings page.
Help others and be happier!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
BG531516382 Thanks Martin, 100% correct
2024-01-01 11:11:54 Útil (0)