Todas as mensagens

Q: Is 5v pin output or input ?

perguntado por Dhrumil sobre 2018-12-28 06:16:48

Kahikatea https://img.staticbg.com/images/oaupload/banggood/images/4E/38/202a38e8-7330-4f41-81d1-f7df4ba3146f.jpg

2019-01-04 03:47:03 Útil (2)
Enviar
respostas (2)

polypagan esp32 has 2 adc's each of which has an analog mux on input (like Uno). this board had 6 analog input in usual location. on digital side, pins go rxd, txd, gpio26 (dac2), 25 (dac1), 17, 16, 27, 14, then 12, 13, 5, 23, 19, 18. followed by gnd, rst, sda, scl.

2019-09-09 01:03:45 Útil (2)
Enviar
respostas (3)

holdenweb Any wall wart should do - the Mini needs less than a fifth of an Amp as I recall. It regulates the 5v from the wall wart down to 3v3 to drive the ESP8266, so digital interface logic should operate at 3v3 unless you want to use level converters. The analogue input pin A0 won't tolerate more than 3.2v so treat it gently.

2019-05-29 02:39:39 Útil (1)
Enviar
respostas (2)

Q: can you give power supply product link ? where to buy ?

perguntado por Dhrumil sobre 2018-07-28 12:37:23

Karmen Maybe you can find it in "Electronics-Arduino Compatible SCM&DIY Kits" Category.

2018-08-01 08:13:22 Útil (0)
Enviar
respostas (1)