Todas as mensagens

Q: What are the dimensions of this; how big or small is it?

perguntado por mbogelund sobre 2019-01-15 08:50:26

babapro31 width 10cm excluding wheel

2022-05-14 02:45:43 Útil (0)
Enviar
respostas (2)

Nico80 Hi! Highest diameter is 1.8mm, min is 1.2 in the middle. Length is 3.5mm. Standard 1:6w resistor size. My Fluke Dmm says the 1% tolerance is there!! 100k=100.0kohm Perfect!

2020-02-29 11:17:45 Útil (1)
Enviar
respostas (2)

Q: What is the diameter of the inlet nozzle?

perguntado por mbogelund sobre 2017-12-21 02:15:52

BG478573815 I have ordered the ID 1848558 hot air gun ,will these fit this gun

2021-10-07 02:45:00 Útil (1)
Enviar
respostas (3)

Q: What are the outer diameters of the reduced end of the two reduction nozzles?

perguntado por mbogelund sobre 2017-12-21 01:50:05

cleres tamanhodo conector: 35 mm

2021-09-11 07:10:20 Útil (0)
Enviar
respostas (1)

Q: Are they breadboard friendly?

perguntado por mbogelund sobre 2017-12-06 02:53:33

fortwonator ifthey are breadboard compatible, the terminals are flexible.

2021-05-08 08:32:23 Útil (0)
Enviar
respostas (2)

Q: Will the output voltage stay the same even if I change the load on the output?

perguntado por mbogelund sobre 2020-07-22 08:20:22

OGHagen Most buck converters when used within limits keep the output voltage pretty well assuming the load increase slowly. A sudden increase in load will usually cause a drop in voltage. However the load vs no-load drop may be significant, so make sure to adjust with a light load. That's what the theory teach us anyways. In practice you will probably see a drop in voltage on the output if you increase the load. How much depends on the load.

2020-09-06 08:17:12 Útil (1)
Enviar
respostas (2)

mbogelund Compro uno de estos y llegado. Si no llega, puedes enviar una reclamacion, y vas a tener tu dinero.

2020-02-27 05:15:29 Útil (0)
Enviar
respostas (1)

Q: what is maximum depth measured by this?

perguntado por himanshusharma0 sobre 2019-04-18 01:55:35

mbogelund That's not how it works, it's not a distance sensor. It doesn't measure the distance from where it's installed to where the water surface is. It measures whether there is water where it's installed or not. So you can for example install it below normal water level and get a message when the water level drops below that point, or install it above normal water level and get a message when the water rises to that point.

2020-02-27 05:09:27 Útil (0)
Enviar
respostas (1)